8/3/2019 Ars Insul Bond

1/3

PRODUCT DATA SHEET - 10330

ARS-INSUL-BONDPRODUCT DESCRIPTION

ARS-INSUL-BOND is a cold-applied, one-part, solvent-free, asphalt/urethane insulation adhesive. It is used to bondapproved insulations to a large variety of approved substrates. It is ideal for projects where solvent odor can be aproblem or when mechanical fasteners cannot be used. It is solvent free and conforms to emission regulations in allcommunities.

RECOMMENDED USES

Recommended for bonding approved roof insulations to structural roof decks, roofing plies, other insulation boardsand smooth, asphalt roof surfaces.

Acceptable Insulation: Polyisocyanurate, Wood Fiber, Dens Deck, Fibrous Glass, or other products approved byAmerican Roofing Systems Corporation.

ADVANTAGES

No open flames, hot kettles, bitumen fumes or pungent solvent odors.

Asbestos free.

Complies with all current VOC regulations including, those involving Ozone Transport Region(OTR) states.

Rapid cure time.

Non-penetrating insulation attachment leads to cleaner jobs, improved safety in regard to belowdeck wiring and equipment

Accepts roof component movement due to wind, temperature and other stressing factors

ORDERING INFORMATION

Available in 5-gallon pails. Color is black.

SHELF LIFE

Six (6) months from date of shipment when stored in unopened, original container.

COVERAGE

Applied directly from the can at 1.5 gallons per 100 square feet to either substrate or insulation board in 12 34diameter beads. Application of four (4) 12 or 34 diameter beads is optimum per 4 x 4 board. Coverage rates maybe slightly higher on irregular surfaces. Increase coverage rate at the roof perimeter and corner areas by applyingadditional ribbons of ARS-INSUL-BOND.

PRODUCT STORAGE

Keep product in range of 70F.

8/3/2019 Ars Insul Bond

2/3

8/3/2019 Ars Insul Bond

3/3

PRODUCT DATA SHEET - 10330

PHYSICAL PROPERTIES

Property Typical Value Method

Asbestos Content 0% EPA 600/R-93/116

Uniformity Pass ASTM D 4479

Elongation 185% ASTM D 2370

Solids by Weight 98.5% ASTM D 4479

Density 10.3 lbs/gal. ASTM D 1475

Viscosity 20,000 35,000 cps ASTM D 2196

Flash Point 300F minimum ASTM D 93

VOC N 12 g/l ASTM D 6511

Minimum values before and after heat conditioning.

American Roofing Systems Corporation

15236 Shedd Rd. Middlefield, Ohio 44062

Phone/Fax: (440) 345-6900

95 Washington St. Suite 104-241 Canton,

MA 02021

Phone Fax: 617 996-0400Toll Free: (800) 330-0652

To the best of our knowledge, all technical data contained herein is true and accurate as of the date of issuance and subject to change without priornotice. User must contact American Roofing Systems Corporation to verify correctness before specifying or ordering. We guarantee our products toconform to the quality control standards established by American Roofing Systems. We assume no responsibility for coverage, performance, or injuriesresulting from use. Liability, if any is limited to replacement of the product. NO OTHER WARRANTY OR GUARANTEE OF ANY KIND IT IS MADE BYAMERICAN ROOF SYSTEMS, EXPRESSED OR IMPLIED, STATUTORY, BY OPERATION OF LAW, OR OTHERWISE, INCLUDINGMERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.