ANAEROBIC GASKET

ANAEROBIC FORMED-IN-PLACE GASKETS, LIKE PERMATEX® ANAEROBIC GASKET MAKER, CURE IN THE ABSENCE OF AIR AND IN THE PRESENCE OF ACTIVE METALS.

ANAEROBIC GASKET MAKER

• OEM specified. Non-corrosive gasketing material designed primarily for use on aluminum, iron, and steel flanged mating surfaces.

• Ideal when a conventional gasket is unavailable (not for use with conventional gaskets).

• Fills gaps up to .015” and cures to a solvent-resistant seal that will not tear or decay during service.

• Parts disassemble easily even after extended service.

• Old gasket material can be removed in minutes with the Permatex Safer Scraper.

• Controlled tolerances: allows metal-to-metal contact.

• Fills potential leak paths: recommended for finely machined surfaces.

• One tube for all shapes and sizes: reduces need for costly gasket inventory.

• 100% seal: eliminates flange face corrosion.

• Single part: easy and clean to apply.

Permatex Anaerobic Benefits:

#51813 #51813

ANAEROBIC ANAEROBIC GASKET MAKERGASKET MAKER

Fills potential leak paths: recommended for finely machined surfaces.Fills potential leak paths: recommended for finely machined surfaces.

One tube for all shapes and sizes: reduces need for costly gasket inventory.One tube for all shapes and sizes: reduces need for costly gasket inventory.

Permatex and Design are TMs of Illinois Tool Works Inc. Copyright © 2016Hartford Square North, 10 Columbus BoulevardHartford, Connecticut 06106 Permatex, an Illinois Tool Works company. All rights reserved. PX-0630

www.permatex.com Find Us. Follow Us. Watch Us.

Anaerobic Gasketing TechnologyTRADITIONAL METHOD TRADITIONAL METHOD PERMATEX® SOLUTION

• Relaxation• Re-torquing

• Corrosion/fretting• Manual application

• Large inventory

• Manual application• Extra machining operation

• Large inventory

• Often solvent-based• Can cause clogging

• Re-torquing• Messy

• Time consuming• Operator skill

• Inconsistent performance

• Constant seal/no re-torquing• Total seal

• Automation possible

• Automation possible• Standard parts used

• No parts to handle• Low inventory

• Solvent-free• Excess material can be wiped away

• No relaxation• Accurate and precise application

• Little preparation• Easy to apply

• Consistent performance

‘O’ RINGS

SEALING

CUT PAPER GASKETSGASKETSGASKETSGASKETSGASKETSGASKETSGASKETSGASKETSGASKETS

PRE-FORMED MATERIALS

Metal Surface Types

Active MetalsResins will fixture on ACTIVE metals in the absence of air within 5 minutes, full cure in 24 hours.

• Steel • Copper • Brass • Bronze • Magnesium • Nickel • Iron

Inactive MetalsINACTIVE metals need to be primed with Permatex® Surface Prep™.

• Bright Platings • Anodized Surfaces • Titanium • Zinc • Pure Aluminum • Stainless Steel • Cadmium

How to Use:To make a gasket:1. Clean both flange surfaces, remove paint, dirt, grease or old gasket completely.2. Spray Permatex® Brake and Parts Cleaner on both flanges. Allow to dry 1-2 minutes.3. Apply a CONTINUOUS bead of sealant, circling bolt holes.4. Assemble mating surfaces with minimal lateral movement. Excess sealant can be wiped away with a cloth andPermatex® Brake and Parts Cleaner.Note: Not recommended for use in oxygen-rich systems or as a sealant for chlorine and other strong oxidizing materials.