y fridge magnet gear...roughly 5mm diameter by 3mm thick. i set my printer to pause at the correct...

Summary

This is a print in place fridge magnet I made for my daughter to play with.It should print in one piece, and once you remove the supports, it shouldspin freely. I had to use a little sandpaper to get enough clearance to reallyget it to spin, but it seemed to work.

This is designed to embed a small magnet in the based on the piece,roughly 5mm diameter by 3mm thick. I set my printer to pause at thecorrect layer height so the magnet hole was still open, and I could place amagnet inside. After that, I had the printer resume, and it printed over thetop of the magnet, sealing it in.

Usage: https://youtu.be/UuUJaFBQPIY

Household > Kitchen

printinplace gears fridgemagnet

Steven Quinn

Fridge magnet gear

VIEW IN BROWSER

updated 18. 10. 2019 | published 18. 10. 2019

3D M

ODEL

ONLY

Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES

237.2 KBupdated 18. 10. 2019

Licence: Creative Commons - AttributionCategory: Kitchen & Dining Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: No

Supports: Yes

Resolution: .2

Infill: 15

Filament: Protopasta HTPLA GunmetalNotes:

When generating support, it needs to be only support coming from thebed. If it's anywhere else, the gear won't spin!

Find source .stl files on Thingiverse.com

The Author has not uploaded any G-codes.Try to search in User G-codes section or generate and upload yourown.

gear_magnet.stl

License

This work is licensed under a Creative Commons (4.0 International License)

Attribution

✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✔ | Commercial Use ✔ | Free Cultural Works ✔ | Meets Open Definition