tape here tape here start here: tape here 5 ...tape here tape here tape here 1 2 hang track on wall...

Press bracket firmly for 30 seconds.

TAPE HERE

Hanging TemplateROTO-ARM REVOLUTIONFOR INSTRUCTIONAL VIDEOS

AND MORE GO TOFOR INSTRUCTIONAL VIDEOS

AND MORE GO TO

www.Hotwheels.com/walltracks

5+Please read all instructions before beginning assembly and set-up.

START HERE:

SEE BACK

SEE REVERSE FOR STEPS 6-9.

STRIPS

5Press bracket firmly for 30 seconds.

™™

X9310-0920G1 SIZE:38” X 23” COLOR: 4C + 1C DOM

Bracketsshould

NOToverlap

template

service.mattel.com

TAPE HERE TAPE HERE

TAPE HERE

Hang Track On Wall

STRIPS

11.5”

STRIPS

Requires 2 – D-size(LR20) alkaline batteries, not included. Dispose of batteries safely.

30 cm12"

STRIPS

NOTE: If claws jam together, gently push them apart. Wait for them to spin and realign before continuing play.

11.5" x 1

Label Sheet

Top Track

CommandBRAND

STRIPS

CommandBRAND

STRIPS

CommandBRAND

STRIPS

BACK VIEW

Switch ON

I=ONO=OFF

GROOVE

PRESS FIRMLYFOR 30 SECONDS

3.5”

CommandStrips

CommaStri

CommandStrips

CommaStri

CommandStrips

3.5" x 1

6" x 2

STRIPS

UPSIDE DOWN Command™ Strip

goes here.

TAB FACES UP

GROOVETAB

STRIPS

Test your skills. Time your launch to destroy the claw!

Bottom Track

Let's Play!Send your cars in different directions!

To remove brackets from the wall entirely: 1 . NEVER pull strip towards you. 2 . Hold bracket gently to prevent it from snapping fingers. DO NOT press against wall. 3 . Grab tab on Command® Strip and SLOWLY STRETCH STRAIGHT DOWN ALONG WALL AT LEAST 12 INCHES until bracket and strip release.

Purchase medium Command® Refill Strips to reapply to your wall.

Mounting brackets are designed to break away from the set without causing surface damage. If mounting plate separates from bracket, snap bracket back into place.

Remove track pieces from wall prior to removing brackets.

Reattaching & Removal

Connect Create your own set-ups with other Wall Tracks™ sets.

X9310-0920G1

©2013 Mattel. All Rights Reserved. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Relations 1-800-524-8697. Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline 01628 500303. Mattel Australia Pty., Ltd., Richmond, Victoria. 3121.Consumer Advisory Service - 1300 135 312. Mattel East Asia Ltd., Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China. Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd.(993532-P) Lot 13.5, 13th Floor, Menara Lien Hoe, Persiaran Tropicana Golf Country Resort, 47410 PJ. Tel:03-78803817, Fax:03-78803867.

Command® Strips are a product of 3M. For further information visit command.com

NOTE: Apply strips to surfaces above 50°F (10°C). Adhesive could lose adhesion above 105°F (40°C).

CAUTION:DO NOT use with wallpaper. May not adhere well to vinyl surfaces.DO NOT hang items over beds.

SEE OTHER SIDE FOR STEPS 1-5

Battery Installation• Unscrew the battery cover with a Phillips head

screwdriver (not included). • Install 2 "D" size (LR20) alkaline batteries (not

included) in the orientation (+/-) shown. • Replace battery cover and tighten screw.• For longer life use alkaline batteries. • Replace batteries when vehicles can no longer

reach the top of the track set.• When exposed to an electrostatic source, the

product may malfunction. To resume normal operation, remove and re-install the batteries.

BATTERY SAFETY INFORMATIONIn exceptional circumstances batteries may leak fluids that can cause a chemical burninjury or ruin your product. To avoid battery leakage:• Non-rechargeable batteries are not to be recharged.• Rechargeable batteries are to be removed from the product before being charged.• Rechargeable batteries are only to be charged under adult supervision.• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.• Do not mix old and new batteries.• Only batteries of the same or equivalent type as recommended are to be used.• Batteries are to be inserted with the correct polarity.• Exhausted batteries are to be removed from the product.• The supply terminals are not to be short-circuited.• Dispose of battery(ies) safely.• Do not dispose of this product in a fire. The batteries inside may explode or leak.

Protect the environment by not disposing of this product with household waste[2002/96/EC]. Check your local authority for recycling advice and facilities.

NOTE: Changes or modifications not expressly approved by the manufacturer responsiblefor compliance could void the user’s authority to operate the equipment.

Remove TemplateOnce all brackets are firmly attached with red arrows correctly oriented, remove template. Note: For optimal adhesion performance 3M recommends waiting 1 hour before adding weight to Command® Strips.

CORRECTCORRECTINCORRECTINCORRECT

Red arrow should line up with arrow on bracket.

Hang Brackets

Press bracket firmly onto wall and hold, pressing for 30 seconds.

Remove black-printed liner from Command® Strips and attach each bracket into the designated notch of the template as shown.

Bracket should not overlap the template.

Prepare BracketsThere are 2 yellow brackets [Marked A – B], 3 flat brackets and 6 Command® Strips (1 extra strip).

NOTE: DO NOT PULL BRACKET OFF WALL without reading removal instructions in step 9.

NOTE: Apply strips to surfaces above 50°F (10°C). Adhesive could lose adhesion above 105°F (40°C).

CAUTION:DO NOT use with wallpaper. May not adhere well to vinyl surfaces.DO NOT hang items over beds.

Hang Template

NOTE TO PARENTS: Before applying Command® Strips make sure the wall surface is clean and dry. If cleaning is necessary 3M recommends using isopropyl rubbing alcohol. Do not use household cleaners.

Lie template flat and level against wall and tape as shown. Top of template should align with the height of the child.

Separate strips. Remove red-printed liner from Command® Strips and apply to back of brackets as shown. Make sure the strip tab is accessible for future removal.

YOU WILL NEED:Low-adhesive tapesuch as painter’stape or masking tape

20 minutes4’

2’2’ Approximately 4 feet by 2 feet of open wall space

Keep these instructions for future reference as they contain important information.

Black Printing = On Wall

Red Printing = On Bracket

Helpful Hint: Apply labels before assembly by number as indicated.

CONTENTS:

Assemble Track Pieces

BACK VIEW

Pre-assemble pieces as shown.

Once brackets are mounted and TEMPLATE IS REMOVED FROM WALL, attach track pieces as shown.

Align tab with groove and push firmly together. If claw does not connect, align and try again.

Load car and launch!

APPLY LABELS

Align tab with groove and push firmly together.If claw does not connect, align and try again.

Warning: Do not aim at eyes or face. Only use projectile supplied with this toy. Do not fire at point blank range.

Coté MUR

WALL sidelado de la PARED lado de la PARED lado de la PARED

lado de la PAREDWALL side WALL side WALL side WALL side WALL side

Coté MURCoté MUR

Coté MUR

Coté MURCoté MUR

Coté MUR

Coté MURCoté MUR

Coté MUR

Coté MURCoté MUR

Coté MUR

lado de la PAREDWALL side WALL side WALL side WALL side

WALL side

Coté MURCoté MUR

Coté MUR

Coté MURCoté MUR

WALL sidelado de la PARED lado de la PARED

lado de la PAREDlado de la PAREDWALL side WALL side WALL side WALL side

WALL side

Coté MURCoté MUR

Coté MUR

STRIPS

CommandStrips

Coté MUR

WALL sidelado de la PAREDlado de la PAREDlado de la PARED

lado de la PARED WALL sideWALL sideWALL sideWALL sideWALL side

Coté MURCoté MUR

Coté MUR

Coté MURCoté MUR

Coté MUR

Coté MURCoté MUR

Coté MUR

Coté MURCoté MUR

Coté MUR

lado de la PARED WALL sideWALL sideWALL sideWALL side

WALL side

Coté MURCoté MUR

Coté MUR

Coté MUR Coté MUR

WALL sidelado de la PAREDlado de la PARED

lado de la PAREDlado de la PARED WALL sideWALL sideWALL sideWALL side

WALL side

Coté MURCoté MUR

Coté MURComm

andStri

CommandStri

STRIPS

CommandStrips

Coté MUR

Coté MURCoté MUR

Coté MUR

Coté MURCoté MUR

Coté MUR

Coté MURCoté MUR

Coté MUR

Coté MURCoté MUR

Coté MUR

lado de la PAREDWALL side WALL side WALL side WALL side

WALL side

Coté MURCoté MUR

Coté MUR

Coté MURCoté MUR

WALL sidelado de la PARED lado de la PARED

lado de la PAREDlado de la PAREDWALL side WALL side WALL side WALL side

WALL side

Coté MURCoté MUR

Coté MUR

2 X 1 X 2 X

tape here tape here start here: tape here 5 ...tape here tape here tape here 1 2 hang track on wall...

Documents

scotch tough duct tape and scotch duct tape...

product catalogue 2019...®impermo acryl-300 acrylic based...

technical manual for fire tape® -...

digitalbloggers.com authenticity - lets cut through the red...

tape here tape here start here: tape here 5+ tape here 5 ·...

prep work is serious business - shurtape® | hvac tape

petroguard petrolatum tape...

medium grade automotive refinishing tape · 2020-01-17 ·...

barbed tape obstacles - allegheny fence · pdf filebarbed...

electrical - realwire web.pdf · electrical tapes pvc...

workforce® 435 - start here here 3remove only the yellow...

vital ink® straight tape splice

safeguard 180o peel & seal tape… · peel & seal tape...

atg 700 adhesive systematg tape 926 high temperature...

solution - shurtape® | hvac tape, duct tape, packaging...

system data sheet sikadur-combiflex® sg system...2019/02/01...

tape loc fittings - jain irrigation...

ibm® lto® ultrium® 7 tape drive performance white...

scotch tough duct tape and scotch duct tape products...

scotch tough duct tape scotch tough duct tape delivers the...