ssg5 vpn lan-to-lan tunnelling
Post on 18-Nov-2014
165 Views
Preview:
DESCRIPTION
TRANSCRIPT
SSG5 VPN LAN-to-LAN Tunneling HOWTO
Bridge Mode
Bridge Mode
** This configuration is based on PPPoE dialing from SSG5, Modem will be on bridge mode.
SSG5 on HQ Configuration
PPPoE CONFIG
Tunnel CONFIG
Define the interfaces by selecting Network> Interfaces from the left panel menu. The tunnel interface is created by selecting Tunnel IF from the drop down menu then Cliking New
Network Interface List
Destination Routing List
AUTOKEY IKE GATEWAY CONFIG
AUTOKEY IKE GATEWAY CONFIG (Advanced)
AUTOKEY IKE CONFIG
AUTOKEY IKE CONFIG (Advanced)
SSG5 on Branch Configuration
PPPoE CONFIG
Network Interface List
Tunnel CONFIG
Define the interfaces by selecting Network> Interfaces from the left panel menu. The tunnel interface is created by selecting Tunnel IF from the drop down menu then Cliking New
AUTOKEY IKE GATEWAY CONFIG
AUTOKEY IKE GATEWAY CONFIG (Advanced)
AUTOKEY IKE CONFIG
AUTOKEY IKE CONFIG (Advanced)
Destination Routing
END
ConclusionThese Application Notes have described the administration steps required to configure a Route-Based Site-to-Site VPN tunnel between the HQ and the Branch site.
VerificationUse “ping” from a PC to verify traffic can traverse through the VPN tunnel. PC fromeither the HQ or Branch network should be able to ping another PC on the oppositeside of the VPN tunnel.
rhisyam at gmail dot com
top related