simply smarter important note technical datadqm2hs0fb20qv.cloudfront.net/wp-content/...adapter and...
Post on 31-Jul-2020
35 Views
Preview:
TRANSCRIPT
The Smart AC Series
Operation Manual
This is an electrical device and should be handled as such.To prevent shock or injury, please keep the iQ2 360W unit awayfrom �re, water and any form of moisture.
This is an electrical device and should be handled as such.To prevent shock or injury, please keep the iQ2 360W unitaway from �re, water and any form of moisture.
DO NOT ATTEMPT to repair or dismantle the iQ2 360W unit. If you are experiencing di�culties operating your unit please contact our Customer Tech and Service Department at1-855-iQ2-7243. Any sign of tampering with the unit may void any Warranty claims.
Use only the approved solar panel and AC charge adapterthat were included with your iQ2 360W. If either of those arebroken and or need to be replaced please contact our technicalsupport division.
Thank you for choosing the iQ2 360W Portable Power Station.The iQ2 360W unit is designed to: provide DC power for lighting,power and charge small accessories: cell phones, iPads, etc via theUSB ports, and provide an electrical power supply for small ACappliances through the built-in inverter. For safe and optimumperformance please use this unit properly. Carefully read andfollow all instructions and guidelines in this manual and give specialattention to ALL WARNING STATEMENTS. Please read the entiremanual before operating the unit.
USB Port
INTERNAL
2000 cycles
Battery
DC OUTPUT
DC Port
12V, 30AH, 360WH
4A
1
WARRANTY and REGISTRATION should be done upon purchasing your iQ2 360W unit. Simply visit our website at: www.iQ2imports.biz
!Due to battery capacity and storage, upon purchasing,the iQ2 360W unit needs to be FULLY CHARGED. If youare charging through the solar panel, simply follow theinstructions and let the unit charge for a FULL 12 - 15 hours,depending on the amount of sunlight. If through the ACadapter, follow the charging instructions and allow the unitto charge overnight. The built-in overload protection willkeep the batteries from overcharging. However, in order toprevent damage, DO NOT leave the iQ2 360W pluggedcontinuously into an AC outlet for more than 24 hours.To guarantee maximum performance and life span, if theunit is being stored and not in continual use, it isrecommended to charge the unit after each use and onceevery 45 days.
LED Light
1
2
1
35W
14.6V, 4A
Accessories Number Designation
IMPORTANT NOTE●
IMPORTANT
NOTE
WARNING
WARNING
WARNING
Technical Data●
Capability, 5V 1.6A, 8W
2 Port number
4
Capability, 12V
Port number
3A, 36W
Solar PanelPower
AC wall charger
12V car adapter
Output Voltage
Port Number
Capability Max
110V
200W
Frequency 60Hz
CHARGING
AC Inverter Outputs
Lithium iron PhosphateBattery Type
Battery Capacity
Life-Span
Optimal ChargingCurrent
Annex●
Solar Panel Power
AC wall charger 1
12V, 3W, and 5m Cables withE27 pin connection and Switch
USB Output iPhone, HTC, Samsung, Nokia, etc.
14.6V, 4A
35 W
Need to car start
360WPORTABLE POWER STATION
Simply Smarter
2
3
5
6
1
4
Front
3. Output USB PortsUSB Ports:2PCS
4. 0utput : DC portsDC Ports:4pcsSize:Φ2.1×6 Output: 12VDC 3A / SET
AC adapter
Car adapter
5. ON/OFFThe switch without control the AC
6. Charger In(Solar In) ,1pcSize:Φ2.5×6Charger In: solar panel
1. Charging and fault lighting
Red-Lighting: charging Red-Lighting: flash
SOLAR CHARGE
OUTPUTUSB DC 5V
OUTPUT DC 12V
OUTPUT DC 12V
OUTPUT DC 12V
OUTPUT DC 12V
OUTPUTUSB DC 5V
Battery level LED indicator
Starting up
Check that the power pack switches are in the “ON” position before charging in.
Recovery voltage
Charging step – By Solar Panel
SOLAR CHARGE
Charging in
Flash - The battery power is low Check that the power pack switches are in the “ON” position,locate the solar panel in direct sun light up to the DC input .
SOLAR CHARGE
Indicates that the system will trigger the low battery Protection,Charging to the recovery voltage , the system can start,Charging to the recovery voltage 12 VDC.
Red-Lighting: charging
Check that the power pack switches are in the “ON” position.
Charge light will turn on while chargingOnce charging completed, four Green lights will stop flashing.
Charging AC Adapter 110V
SOLAR CHARGE
Red-Lighting: charging
Charging in that the four instructions without rules of �ash.
DC OUTPUT
Support USB charging or load to use.Mobile phone chargingUSB*2 parallel output: 5 VDC / 1.6 A General USB output, Support USB charging or load use.
DC jack * 4pcs (5.5*2.1) output:12 VDC,Single-port maximum output 12 VDC / 3A (36W)General use as lighting and etc DC.Includes overload and reverse polarity protection connect using the extension leads of Cigarette LighterAdapter and turn on via the inline switch to each light.
AC Inverter output
Inverter unit runs a loss, when not in use, please turn the main switch o�.
SMART AC inverter output as independent system;Please pay attention to the power AC load, no more than inverter capacity 200W.
The iQ2 360W has a built-in intelligent temperature controlled fan that cools the inverter and will automatically start at 45 C.
Overload and short circuit protection
SOLAR CHARGE
OUTPUTUSB DC 5V
OUTPUT DC 12V
OUTPUT DC 12V
OUTPUT DC 12V
OUTPUT DC 12V
OUTPUTUSB DC 5V
Red �ash - Includes overload and etc protection.
Please turn o� the power switch & Disconnect the load andthen restart.
Includes overload and etc protection.Please turn o� the inverter of power switch & disconnect theload and then restart.
2. Battery Charge Level
Green lighting
SOLAR CHARGE
!
Operation● Operation●Variants●
Push
!
Rear
78
9
7. AC ON / OFF
8. AC output, 1pc
9. AC output indicator light
5VDC 0.6A
5VDC 1A
The iQ2 360W Solar Power Pack is equipped with several built-in safety features. In the event your battery has been fully depleted, and or the unit is not taking a charge (RED charge light indicator will be on while charging) you will need to follow the following charging instructions below in order to reset the Battery Discharge Safety:
* Make sure unit power is "ON" while charging.* Pull charging cord plug, either solar or AC charging, doesn't matter, out of the charging port.* Insert the charge cord plug into the #4 DC Output port. IMPORTANT NOTE: Both the RED charge light indicator and GREEN light charge gauge will light up immediately...REMOVE the charge cord plug from the DC port.* Re-insert charging cord plug into the charging port. The unit will continue charging.* Once the unit is charging the indicator lights will begin to flash.
The AC adapter box will get warm during charging.
SPECIAL NOTE: For maximum battery performance and longevity, it is recommended that you do not fully deplete the battery. Keep the battery charged above 25%.
top related