organization of 30 cfr the mine health and safety act the msha guidance sections, parts a, b, p, q...
Post on 26-Dec-2015
213 Views
Preview:
TRANSCRIPT
Organization of 30 CFRThe Mine Health and Safety Act
The MSHA Guidance Sections, Parts A, B, P, Q
©Feb 2003 Dr. Bradley C Paul
Structure of CFR 30
• Chapter A just establishes MSHA’s logo and paper work requirements
• Devices used in mines, especially underground coal mines must be tested and approved for safety– Mechanism for determining safety and basic
safety considerations are found in Chapter B
The Executioner
• Chapter P proscribes the Civil Penalties for Violations of the Act– MSHA uses a triangle of methods to make
safety a part of Mining Culture• Education and Training
• Providing Technical Assistance
• Kicking peoples heinies up around their ears
Taking Action Now
• Mine Inspectors observing conditions that are immediately life threatening– Section 107(a) Imminent Danger Order– Shuts down and pulls people out immediately
• Must be imminent danger that will kill or injure in a short time (or reasonable could)
• If accident has occurred MSHA can issue a Section 103(k) order {Also called K order}– Evacuates any area or whole mine until investigation can confirm
hazard has been abated.– Must believe the condition still exists or could exist
• If it seems to not follow CFR layout its because it is written directly into the law.
Other Orders
• MSHA can take over the investigation or rescue with a J order– Seldom used in past although being used more
aggressively now.
Most Violations are Called 104(a)
• Regular Penalty Assessment– Filed Against the mine operator – up to $60,000 per
violation (effective Feb 13, 2003)– Each violation (may be same violation caught on
different days) may be fined separately
• Single Penalty Assessment– Can get penalty cut to $60
• If get things fixed as fast as inspector asks• If few violations in last two years
– Less than 10 home free– Less than 20 probably ok
How to Gage a Regular Assessment
• Penalty Severity is a function of– Size of the Business– Previous History– Operator Negligence– Gravity of Violation– Operator Good Faith in Rapid Correction– Ability of the Operator to Continue in Business
• Each of the Factors is assessed using a formula table
• Points are all added up and then converted into a $ amount
The Size of Business Factor
• Coal Operations are Assessed based on Tonnage– Based on Tonnage of Mine– And Tonnage Controlled by Operator
• (ie Consol get nailed harder than Moes Coals)
• Metal Mines and Independent Contractors are Assessed based on Employee Hours Worked– Also Consider both size of mine and
controlling entity
Coal Mine Business Size
• <15,000 tpy = 0 points• <30,000 tpy = 1 point• <50,000 tpy = 2 points• <100,000 tpy = 3 points• <200,000 tpy = 4 points• <300,000 tpy = 5 points• <500,000 tpy = 6 points• <800,000 tpy = 7 points• <1,100,000 tpy = 8 points• <2,000,000 tpy = 9 points• >2 million tpy = 10 points
Controlling Company Size (Coal Mines)
• <100,000 tpy = 0 points
• <700,000 tpy = 1 point
• <1,500,000 tpy = 2 points
• <5,000,000 tpy = 3 points
• <10,000,000 tpy = 4 points
• >10 million tpy = 5 points
• Note a big company can rack-up 15 points
The Case of the Metal Mine
• <10,000 hrs/yr worked = 0 points• <20,000 hrs/yr = 1 points• <30,000 hrs/yr = 2 points• <60,000 hrs/yr = 3 points• <100,000 hrs/yr = 4 points• <200,000 = 5 points• <300,000 = 6 points• <500,000 = 7 points• <700,000 = 8 points• <1,000,0000 = 9 points• >1 Million hrs/ yr = 10 points
Parent Metal Mining Company
• <60,000 hrs/yr = 0 points• <400,000 hrs/yr = 1 point• <900,000 hrs/yr = 2 points• <3,000,000 hrs/yr = 3 points• <6,000,000 hrs/yr = 4 points• > 6 million hrs/yr = 5 points• Note that big Metal companies can get 15 points
also
The Case of the Contractor
• Some Mining Companies hire independent contractors to handle actual mining operation– Others use for specialty projects such as shaft sinking
or construction projects• Independent Contractors usually fined as
individual entity– Have the same schedule as metal mines in terms of
hours worked• There is no check for parent company size
– Thus Independent Contractors can only accumulate 10 points under size of operation criteria
Previous History
• For Mine Operator (Coal or Metal)– Basis is the average number of violations per inspection day during
previous 24 months• Only those that are settled and paid count
– The Table• <0.3 = 0 points• <0.5 = 2 points• <0.7 = 4 points• <0.9 = 6 points• <1.1 = 8 points• <1.3 = 10 points• <1.5 = 12 points• <1.7 = 14 points• <1.9 = 16 points• <2.1 = 18 points• >2.1 = 20 points
History for Independent Contractors
• Based on total number of violations for all operations– 1 to 5 = 0 points– 6 to 10 = 2 points– 11 to 15 = 4 points– 16 to 20 = 6 points– 21 to 25 = 8 points– 26 to 30 = 10 points– 31 to 35 = 12 points– 36 to 40 = 14 points– 41 to 45 = 16 points– 46 to 50 = 18 points– >50 = 20 points
Degree of Negligence
• Assessed up to 25 points– (No Negligence) Operator was diligent and could not
have known 0 points– (Low Negligence) Operator knew (or should have
known) but there were a lot of mitigating circumstances 10 points
– (Moderate Negligence) Operator knew (or should have) but there are mitigating circumstances = 15 points
– (High Negligence) Operator knew (or should have) and there is no excuse = 20 points
– (Reckless Disregard) Operator didn’t care in the slightest = 25 points
Gravity and Seriousness
• Up to 30 points are calculated from the tables below– Likelihood of Occurrence
• No likelihood = 0 points• Unlikely = 2 points• Reasonably Likely = 5 points• Highly Likely = 7 points• Occurred = 10 points
– Severity of injury if Occurred or if it Occurred• No lost work days = 0 points• Cause 1 or more lost work days or restricted duty = 3 points• Permanently Disables a part or function of the body = 7 points• Did or reasonably likely to cause death = 10 points
Gravity Table #3
• Number of People Potentially Affected– 0 People = 0 Points– 1 Person = 1 Point– 2 Persons = 2 Points– 3 Persons = 4 Points– 4 to 5 Persons = 6 Points– 6 to 9 Persons = 8 Points– 10 or more = 10 Points
Good Faith of Operator
• Operator Abates the violation in time set by the inspector– Give a 30% discount on fine
• Operator does not abate the violation in time set by the inspector– Wack the disobedient sucker with another 10
points
Totaling Up a Regular Assessment
• Add up all the points for the violation and convert to $ with the table below– <21 points = $72 31 points = $178– 21 points = $80 32 points = $193– 22 points = $87 33 points = $207– 23 points = $94 34 points = $221– 24 points = $101 35 points = $234– 25 points = $109 36 points = $254– 26 points = $120 37 points = $273– 27 points = $131 38 points = $291– 28 points = $142 39 points = $310– 29 points = $153 40 points = $327– 30 points = $164 41 points = $354
The Fines Steepen
• 42 points = $383 55 points = $1769• 43 points = $409 56 points = $2003• 44 points = $437 57 points = $2252• 45 points = $463 58 points = $2515• 46 points = $500 59 points = $2793• 47 points = $536 60 points = $3086• 48 points = $629 61 points = $3419• 49 point = $749 62 points = $3770• 50 points = $878 63 points = $4137• 51 points = $1033 64 points = $4521• 52 points = $1198 65 points = $4856• 53 points = $1376 66 points = $5099• 54 points = $1566 67 points = $5342
Stiffening the Mix
• 68 points = $5585 81 points = $11535• 69 points = $5828 82 points = $12794• 70 points = $6071 83 points =$13963• 71 points = $6374 84 points = $15177• 72 points = $6678 85 points = $16392• 73 points = $6981 86 points = $18213• 74 points = $7285 87 points = $20642• 75 points = $7588 88 points = $23070• 76 points = $7892 89 points = $25498• 77 points = $8499 90 points = $27927• 78 points = $9106 91 points = $30355• 79 points = $9713 92 points = $33391• 80 points = $10321 93 points = $36427
Maxing Out
• 94 points = $39462
• 95 points = $42498
• 96 points = $45533
• 97 points = $48569
• 98 points = $51605
• 99 points = $54640
• 100 points = $60000
Dealing With People Who Don’t Get It
• People who do not abate 104(a) in a timely manner– Obviously they get hit with extra points and
cost– If no good reason to extend time they issue a
104(b) order – The B order• Pulls miners out of mine or area until the condition
is fixed
Special Assessments for Knotty Boys
• Reserved for special aggravating circumstances and non-submissive actions– Involved death or serious injury (and MSHA is ticked
or under political pressure)– Hurting the MSHA reps feelings by not letting him/her
do the inspection when they wanted– Violations where an individual is personally liable– Violations involving imminent danger– Discriminating against squealers– Extraordinary negligence
Can be Focused on Individual
• Special Assessments– $6,500 per day per violation
• Can Go After Individual– $275 for individual miners who carry smoking
materials with them– Penalties can also be against individuals
Unwarranted Failure to Comply
• More than being stupid careless – defiant– Ran mine when shut down– Ignored an imminent danger order– Ignored other order and suggested MSHA take
a spin on their middle finger
• 104(d) order
Chapter Q – A Pattern of Violations {104(e) orders}
• A pattern exists if– Significant and substantial violations
• Mine got closed down a bunch• Lots of imminent danger orders
– Lots Enforcement Actions• Also lack of good faith in correcting
– A bad accident and injury record
• If determined have to post notice of the pattern and the violations– Also for sure on their list
Life Under 104(e)
• MSHA monitors whether a pattern is developing– Issues a potential pattern of violations notice
• If criteria are met MSHA issues a Final Pattern of Violations notice
• Have to post notice on boards• For next 90 days if inspection finds any significant or
substantial violation– Issue 104(e)(1) order – evacuate area– Can keep going through the mine issuing 104(e)(1) orders– Shut down until abated
• You stay on notice till your conduct determines that MSHA can issue a termination order for the pattern
top related