nokia wcdma ultrasite supreme indoor

1 Supreme WCDMA Indoor Installation v1.0/April 2006

Nokia WCDMA Ultrasite Supreme BTS

WCDMA BTS Cabinet and

Unit Installation

Environmental requirements• Storage conditions (please refer to user manual)

• Transportation conditions (please refer to user manual)

• Operating conditions• Climatic conditions for operation

Temperature range -5°C to +50°C Relative humidity 5% to 95% Solar radiation No

• Water resistance IP Class 20 Solar radiation No Icing and frosting allowed Yes

• Acoustic noise 56 dB(A) night time ; 65dB(A) day time

• EMC (please refer user manual)• Safety (please refer to user manual• Nokia Ultrasite WCDMA BTS inner circuit enclosure is weather-proof to

prevent the ingress of rain and snow• The indoor cabinet is weatherproof to a minimum level of IP20 (Outdoor

IP55 )

Preparing the site for cabinet installation

1. Check that the cabinet(s) can be installed safely:

• Site is prepared according to drawings

• Site survey is complete

• Site survey report is available

• Site is clean

• Product delivery is complete

• All wiring is done in accordance with national electric code

• Lifting equipment and other equipment is available as defined in the Site Survey

Report

• Sufficient service clearances are available

2. Verify that the following external cabinet connections are available:

• Grounding bus bar

• Mains power (AC or DC, depending on the site)

• Transmission connection point

Bolt / Screw Type

DIN Size Torque

Nut 934 A2 M5 3.7 Nm

Nut (cabinet fixing)

934 A2 M12 49 Nm*

Knurled-head screw (finger tightening)

-NA- M5 approx. 1 Nm

Fan fixing screws, plastic

M4 0.7 Nm

Fan fixing screws, metal

M4 1.2 Nm

* The exception to this is the DC strain relief fixing screw, which should be tightened to 4 Nm.

Torque Recommendations

Connector Torque

SMA 1 Nm

N 1 Nm

7/16 25 Nm

TQ Hand adjustment

roof/DC terminal 6 Nm

D 0.2 – 0.3 Nm

Standard Installation tools

Lifting the cabinet core

Installing the cabinet feet

Empty core cabinet

Mounting and anchoring the cabinet

NOTE: Dimensions: mm (in.)

300(11.8)

150(5.9)

300 (11.8)

16 (0.6)

optional fixing points

145 (5.7)

96 (3.8)

600 (23.6)

359(14.1)

900(35.4)

Space for door opening

optional fixing points

Anchoring the cabinet

Installing the Indoor Kit (WIKA)

Install the roof mask only after all the cables are connected

Installing the door

Cabinet gronding

DC filter installation

Unit installation

Always use antistatic wrist strap

• Do not remove protective packing from units before installation

• Always use the antistatic wrist strap

• Heavy units are WAF, WPA, WTR, WPS, and WFA

• Install units to slots with care to avoid damage to the back planes and connectors

• Test the power cabling before installing any of units

Working order• Install the cabinet as in the following order:

1) Antenna cable cover2) Grounding cable3) Antenna Filter (WAF)4) Power Amplifier (WPA)5) Transceivers (WTR)6) Input Combiners (WIC)7) Summing Units (WSM)8) Signal Processor Units (WSP)9) Application Manager (WAM)10) Power Supply Units (WPS)11) System Clock Units (WSC)12) ATM Transmission Units (AXU)13) Interface Units (IFU)14) RF-Cabling15) External Alarm Unit (WEA)

Unit positions

1+1+1 Configuration

1- omni Configuration

1+1 and 2+2+2 Configurations

Installing the WAF units

(WAF) Antenna Filter Unit

Installing the WPA units

(WPA) Power Amplifier Units

Installing the WTR units

(WTR) Transmitter and Receiver Units

Installing the WIC units

(WIC) Input Combiner

Inserting modules with ejectors

Installing the WSM units

(WSM) Summing and Multiplexing Unit

Installing the WSP units

(WSP) Signal Processor Unit

Installing the WAM units

(WAM) Application Manager Unit

Installing the WPS units

(WPS) Power Supply Unit

Installing the WSC units

(WSC) System Clock Unit

Removing the EMC shelter

Installing the AXU unit

(AXU) ATM Cross-connect Unit

Installing the interface units (IFU`s)

IFUA (IFU) Interface Unit

Installing the WEA

(WTR) Transmitter and Receiver Units

Unit cabling

Unit cable sizes

Connecting Front Cables

Routing Transmission Cables

WSM Cabling

External Alarms

nokia wcdma ultrasite supreme indoor

unit installation

indoor cabinet

standard installation

indoor kit wikainstall

receiver units

summing units wsm

power supply units wps

interface units ifu

Documents

nokia - wcdma 4 beginners tutorial

ultrasite installation

2.0 nokia ultrasite edge base station product description -...

nokia conference call second quarter 2006 financian · pdf...

nokia e75 data sheet - tsr.blogs.com · nokia e75 data...

nokia ultrasite wcdma bts optima compact (wreb), bts...

bts alarm descriptions - st3...

72060182 nokia ultrasite wcdma bts supreme indoor winb bts...

nokia - introduction to wcdma

faculty of technology information technology - umts...

ultrasite user’s guide rmcc supplement -...

prof. yrjö neuvo member of nokia executive board. yrjö...

nokia wcdma bts commissioning

nokia ultrasite wcdma bts supreme indoor (winb), bts...

trends in networks research - cwc.oulu.fi · pdf filetrends...

introduction to wcdma fundamentals nokia

nokia 3g wcdma system delivery

nokia flexi wcdma base station data sheet (first generation)

05m1 lecture combinatorial optimization and...

bts ultrasite