envision - gses.com...computed variable control • introduction • internal reflux control model...

A self-paced MultiMedia based Tutorial/CBT on Process Control Advanced Concepts.

Tutorial/CBT:

This interactive course explains the Advanced Concepts of Process Control and Dynamics using Voice, Video, Animation and Graphics.

Introduction• Overview of

Conventional Control• Overview of Advanced

Control• Block Diagrams• Definitions

Process Dynamics• Introduction• Process Characteristics• Linear Systems

PID Controller• Introduction• PID Gap Controller• Variations of PID

Controller• Advanced Options in

PID Controller• Computer Control

Adaptive Control• Introduction• Gain Scheduling• Auto Tuning• Self Tuning Regulator• Model Reference

Adaptive Control

Dead Time Compensation• Introduction• Smith Predictor

Algorithm• Implementation

Feedforward Control• Introduction• Steady State

Feedforward Control• Dynamic Feedforward

Control• Feedforward

Algorithm• Combined

Feedforward and Feedback Control

Non-Interacting Control• Introduction• Interaction Analysis• Decoupler Design

Computed Variable Control • Introduction• Internal Reflux Control

Model Predictive Control• Introduction• Process Model• Model Predictive

Control• Key Parameters• Example

Intelligent Control• Introduction• Neural Network Based• Control• Fuzzy Logic Control

Advanced Process Control Tutorial and Simulation

GSE Systems www.gses.com/EnVision

• Tutorial has a built-in Quiz and comes with a Learning Management System (LMS) called TutAdmin. The LMS allows an instructor to register trainees and monitor their performance and Quiz scores

• Tutorial is available as a Standalone or Web based application

EnVisione-Learning & Universal Simulation

Advanced Process Control Tutorial and SimulationEnVision

Simulation Modules:

Distillation Process Control Modules

• Dead Time Compensation Control• Non-Interacting Control• Internal Reflux Control• Dual Composition Control• Model Predictive Control

Furnace Process Control Modules

• Furnace Combustion Control• Furnace Pass Balance Control

• Simulation comes with a Learning Management System (LMS) called SimAdmin that allows an instructor to register trainees and monitor their performance

• Simulation is available as Standalone (Single or Dual Monitor) and Instructor-Trainee versions

EnVision

EnVision™ is a trademark of GSE Systems, Inc. All other trademarks are the property of their respective owners. The information in this literature is subject to change without notice and is not to be construed as a warranty.

DS.ENV.15.VC 0616

GSE Systems, Inc. 1332 Londontown Boulevard, Suite 200, Sykesville, Maryland 21784 USA

T: +1 410.970.7800T: 800.638.7912 (U.S. only)F: +1 410.970.7997E: envisioninfo@gses.comwww.gses.com