ccna 640-802 - 3rd may 2011 (1)

CCNA 640-802

Three simulations were VTP, ACL and EIGRP (From 9tut.com)

Note: These are 40 Questions + 3 Sims (43). I am not able to remember the other 10 Questions.

There was a twisted question in VTP simulation as follows,

The VTP was last updated by 192.168.1.250 but the IP addresses of the 2 neighboring switches were 192.168.1.247 and 192.168.1.249. So the 3rd Switch in the network which is not adjacent to Sw-AC3 should have updated the VTP.

*********************************************************************************

Other questions not in Dumps:

1. Which command will change the VTP domain name to null after you restart the switch?Ans: Erase vlan.dat

2. What are the 2 states are the RSTP states when the network has converged?Ans: Fordwarding and Disabled.

3. Which Cisco IOS diagnostic command can disrupt the operation of a router under high load conditions?Ans: Debug all

4. Which options are based on the standard access lists?Ans: Source Address and Wilcard mask

5. What is the IPV6 multicast address used by RIPng routing protocol?Ans: FF02::9

6. While troubleshooting ACL which command will show what interfaces are affected by the ACL?Ans: Show interfaces

7. What is the effect of using Service Password-Encryption command?Ans: It will encrypt all current and future passwords.

8. There was a VLAN question where a Host A in VLAN1 is able to Telnet into Switch but Host B in VLAN 33 is not able to ping or telnet into the same Switch. Ans: The router interface is down due to which HostB in VLAN33 is unable to communicate with Switch management VLAN1.

From Acme 356Q dumps:

9.

10.

11.

Note: Scenario was as the packet leaves RouterB towards RouterA.

12.

13.

14.

15.

16.

17.

18.

19.

20.

21.

22.

23.

24.

25.

26.

27.

28.

29.

30.

31.

32.

33.

34.

35.

36.

37.

(Subnet masks were given as options instead of CIDR values)

38.

39.

40.