2005-07 dodge magnum - scosche · 2015. 10. 9. · 2005-07. dodge magnum images front speakers rear...

+12v Constant = Gray/Green +12v Acc. Switch = -12v Chassis Ground= Black/Gray +12v Illumanation = +12v Dimmer = Amp Remote = Can-Bus = White/Orange & White

LF+ = Gray/PurpleLF- = Gray/Yellow

RF+ = Green/Purple RF- = Green/Yellow LR+ = Green/Orange LR- = Green/Yellow RR+ = Yellow/Pink RR- = Green/Brown

Dash Type : Din and 1/2/Double DinAftermarket Type: Single/Double DinKit: CR1286B/CR1289BHarness: CR03SRAntenna Adapter: CRAB/CRARB

Interface Adapter(s): Can-Bus Protocol (TBA)

About the Vehicle

Make: DodgeModel: MagnumYear: 2005-07

In Dash Application

Wire Color Codes

Speaker Notes

Front Speaker Sizes

Rear

Dodge Magnum

NOTES

Dimensions:

Dimensions: W= L= D=

NOTES

Rear Deck: 6x9'' MidrangeSpeaker Adapter: SA69Speaker Harness: TBAFactory Assembly: (4) T-20 screws securingspeaker.

Standard/OptionalSix-speaker, 288-watt Boston Acoustics sound system.CD PlayerNavigation SystemMP3-compatible In-dash CD changerDVD Player

Ampli�er Locations:Behind Drivers Side Knee Bolster.

W= L= D= 3.35''

Type: Standard Audio System Location: At Speakers

Front Dash : 3'' FullrangeLower Door: 6X9” MidbassSpeaker Adapter: SA69Speaker Harness: TBAFactory Assembly: (4) T-20 screws securingspeaker.

Speaker Sizes

The front dash 3'' speaker is standardonly on the Boston Acoustic System.

2005-07

Dodge Magnum

Images

Front Speakers

Rear Speakers

Radio removal

Front Speakers

Rear Speakers

Using a PRT remove both "A" pillars.2. Using a PRT pry upwards on the dash panel torelease the (11) clips securing the dash panel to the top of the dash.3. Extract (2) PHS securing the speaker to the dash.

1. Remove the rubber pad just in front of the shifter.Extract (2) PHS from underneath the pad.2. Using a PRT remove the trim around the shifter.3. Using a PRT remove the whole trim panel that is around the shifter that goes to the bottom of the ash tray.4. Using a PRT remove the ash tray trim panel.5. Using a PRT remove the trim around the radioand A/C controls.6. Extract 4 PHS securing the radio to the dash.Disconnect and remove.

Radio

Dash Fullrange

Recommended: Disconnect negative battery cable

A Pillar Tweeter

Door Speakers1. Using a hook tool lift the screw cover on the door release handle panel. Extract (1) PHS behindthe cover.2. Using a hook tool lift the screw cover just belowthe arm rest. Extract (1) PHS from behind the cover.3. Using a small center punch push in the pop-tabrelease pins on outer rim of door panel. (1) on frontsill, (2) on rear sill.4. Extract (4) PHS from lower door panel.5. Using a PRT remove door panel. Disconnect and remove.6. Using a T-20 torx bit extract (4) T-20 screwssecuring speaker to factory speaker adapter.Disconnect and remove.

Door Speakers Using a PHS driver remove (1) PHS securingspeaker cover panel to rear side panel. Removespeaker panel.2. Extract (4) T-20 screws securing speaker tofactory speaker adapter. Disconnect and remove.

2005-07