11_perforadora montabert hc50
Post on 20-Jul-2016
885 Views
Preview:
TRANSCRIPT
RESEMIN S.A.
11
PERFORADORA
MONTABERT
09 / 201000
CPN 86715729
HC50 S E 067 W B 38 M B
86712171( Ø 38 --- T38 )
P
T
Q
MAINTENANCE LEGEND
Every 400 hours.
Depending on applications.
Every 800 hours.
PARTS TO CHANGE
CAUTION
If drifter settings are incorrect, wear parts can be damaged prematurely.
If the drifter is used with deflated accumulators, premature damage can be caused to all parts.
These inspection intervals can vary depending on ground conditions, use of drifter.......
Every 100 hours.
Every 1600 hours.
Long term, only if damaged.
E MONTABERT -- 2010 Item Page
A DISTRIBUTION PART PARTIE DISTRIBUTION 1.1
B MOTOR PART PARTIE MOTEUR 1.2
C HOUSING ASSEMBLY PARTIE CARTER 1.3
D FRONT GUIDE Ø 38 GUIDE AVANT Ø 38 1.5
E ADAPTERS ADAPTEURS 1.6
F FIXATION FIXATION 1.7
A
B
C
F
D E
Item CPN QtyE MONTABERT -- 2010
1.1
Distribution Distribution
10 86343290 1 Cover Couvercle
D 20 86363595 1 O’ring Joint torique
30 86343282 1 Push rod Poussoir
40 86343274 1 Push rod liner Chemise de poussoir
50 86333879 1 Valve Clapet
60 86343217 1 Distribution cover Couvercle de distribution
70 86343225 1 Distribution box Boîte de distribution
80 86333861 1 Distributor Distributeur
90 86333846 1 Thrust piston “E” Piston de poussée “E”
100 86318516 1 Pin Axe lisse
110 86325032 1 Cylinder Cylindre
D 120 86265071 2 O’ring Joint torique
130 NA 1 Energy chamber including : Réservoir d’énergie comp. :
140 86374014 1 ( Body ( Corps
150 86374055 2 ( Cover ( Couvercle
D 160 86376191 2 ( O’ring ( Joint torique
170 86633963 2 ( Diaphragm kit including : ( Kit membrane comprenant :
180 86241403 1 -- BS ring -- Bague BS
190 86265048 1 -- Inflating screw -- Vis de gonflage
200 86334034 4 Assembling screw (rear) Vis d’assemblage (arrière)
110
90
80
60
50
30
40
70
100
20 10
120
200
190180
160
150
170
140
130
+
300 Nm220 ft.lb
1400 Nm1035 ft.lb
22 Nm16 ft.lb
Every 400 hours.
Depending on applications.
Every 1600 hours.
Long term, only if damaged.
Every 100 hours.
Every 800 hours.
PARTS TO CHANGE
300 Nm220 ft.lb
1.2Item CPN QtyE MONTABERT -- 2010
Motor part Partie moteur
10 86333838 1 Striking piston Piston de frappe
20 86334299 1 Down cylinder Bas de cylindre
30 86386794 1 Motor body Corps de moteur
40 86223476 1 Spring Ressort
50 86223419 1 Pin Axe lisse
60 86322518 3 Valve Clapet
D 70 86570447 1 Tight seal Joint d’étanchéité
D 80 86238201 2 O’ring Joint torique
D 90 86292786 1 O’ring Joint torique
100 86249265 1 Plastic plug Bouchon plastique
110 86313053 1 Cover Couvercle
D 120 86222668 1 O’ring Joint torique
130 86344116 1 Bearing holder plate Plaque porte roulement
140 86223559 1 Ball bearing Roulement à billes
150 86344199 2 Distribution plate Platine de distribution
D 160 86261344 2 O’ring Joint torique
170 86640117 1 Cartridge ( 067 cm3 ) Cartouche ( 067 cm3 )
180 86318516 2 Pin Axe lisse
D 190 86221918 2 O’ring Joint torique
200 86334109 1 Thrust lining Chemise de butée
D 210 86238201 2 O’ring Joint torique
D 220 86300936 2 Rod joint Joint de tige
230 86334117 1 Hydraulic stop piston Piston de butée
D 240 86334174 2 Lip seal Joint à lèvres
40
160
180
150
160
190
140
120 110
190
130
180
150
60
70
80
90
5030 80
20 10
100
220
230
200
210 240
170
Every 400 hours.
Depending on applications.
Every 1600 hours.
Long term, only if damaged.
Every 100 hours.
Every 800 hours.
PARTS TO CHANGE
600 Nm440 ft.lb
334,7mmmini13.17”mini
Item CPN QtyE MONTABERT -- 2010
1.3
Housing assembly Partie carter
10 86386216 1 Complete housing including : Carter complet comprenant :
20 86264678 8 ( Helicoil thread UNF 3/4” ( Filet hélicoïl UNF 3/4”
D 30 86292786 2 O’ring Joint torique
D 40 86570447 9 Tight seal Joint d’étanchéité
50 86323763 1 Snap ring Jonc
D 60 86334133 1 Centering part Centreur
70 86334125 1 Shank thrust Butée d’emmanchement
80 86323771 2 Tight ring Bague d’étanchéité
D 90 86232766 6 O’ring Joint torique
100 86323797 2 Tight ring Bague d’étanchéité
110 86323789 1 Tight ring Bague d’étanchéité
120 86323805 1 Seal holder ring Bague porte--joint
D 130 86322278 2 Lip seal Joint à lèvres
140 86323813 1 Shouldered ring including : Bague épaulée comprenant :
150 86322252 1 ( Self lubricating ring ( Bague autolubrifiante
160 86322260 2 Needle bearing Roulement à aiguilles
170 86323953 1 Gear driving shaft Arbre de transmission
180 13900717 1 Ball bearing Roulement à billes
190 86334141 1 Gear driving including : Pignon récepteur comprenant :
200 86605920 1 ( Spline shank ( Ecrou cannelé
210 86250107 2 Needle bearing Roulement à aiguilles
220 86582855 1 Thrust washer Rondelle de butée
4030 70 6010
50
140
170180
190
210
220
20
200
80110
130
90
120
9080
160
100
100
160150
Every 400 hours.
Depending on applications.
Every 1600 hours.
Long term, only if damaged.
Every 100 hours.
Every 800 hours.
PARTS TO CHANGE
7,2 mm mini0.28” mini
210
1.4Item CPN QtyE MONTABERT -- 2010
D 230 86288131 1 BS ring Bague BS
240 86366259 1 Slider Tiroir
250 86366242 1 Lining Chemise de tiroir
260 86366283 1 Spring Ressort
D 270 86234994 1 O’ring Joint torique
280 86234853 1 O’ring Joint torique
290 86312196 x Adjusting shim Rondelle de calage
300 86334166 1 Flange including : Flasque comprenant :
310 86256005 2 ( Helicoil thread UNF 1” ( Filet hélicoïl UNF 1”
D 320 86288222 1 O’ring Joint torique
330 86655354 1 Oiler Graisseur
D 340 86570447 1 Tight seal Joint d’étanchéité
350 95340659 4 Assembling screw Vis d’assemblage
300
320
330
340
350290240250 230260
280270
Every 400 hours.
Depending on applications.
Every 1600 hours.
Long term, only if damaged.
Every 100 hours.
Every 800 hours.
PARTS TO CHANGE
10 mm maxi0.393” maxi
Ø 54 mmmaxiØ 2.1“ maxi
300 Nm220 ft.lb
300 Nm220 ft.lb
310
Item CPN QtyE MONTABERT -- 2010
1.5
Front guide Guide avant
10 86708666 1 Front guide including : Guide avant comprenant :
20 86259660 1 ( Elastic pin ( Goupille élastique
30 86706785 1 ( Guiding ring ( Bague de guidage
D 40 86220480 1 ( Spring ( Ressort
D 50 86375870 1 ( Ball ( Bille inox
D 60 86578671 1 ( Seal ( Joint
D 70 86570447 1 ( Tight seal ( Joint d’étanchéité
D 80 86668969 1 ( O’ring ( Joint torique
90 86307162 1 ( Lip seal ( Joint à lèvres
100 86607355 2 UNF 1”, hex. screw Vis H UNF 1”
110 86706827 1 Retainer chuck Douille de décaleur
120 86307162 2 Lip seal Joint à lèvres
130 86334240 1 Shield Protection
140 86619566 1 Male shank T 38 Emmanchement mâle T 38
150 86331766 1 Adapter Adapteur
Ø 38
130
120
110
90
80
70
60
10
20
30
4050
140100
120
Every 400 hours.
Depending on applications.
Every 1600 hours.
Long term, only if damaged.
Every 100 hours.
Every 800 hours.
PARTS TO CHANGE
300 Nm220 ft.lb
150
1.6Item CPN QtyE MONTABERT -- 2010
Adapters Adapteurs
For water flushing Pour injection d’eau10 95219747 1 Adapter ( P2 ) Adapteur ( P2 )
20 86321056 1 Adapter ( Flushing ) Adapteur ( Injection )
30 95219762 1 Adapter ( Return ) Adapteur ( Retour )
40 86257979 4 Adapter ( P1A -- P1R --Drain -- Pressurization )
Adapteur ( P1A -- P1R --Drain -- Pressurisation )
oil restrictor gicleur réglable
86374964 1 Oil restrictor including : Gicleur réglable comprenant :
10 86374972 1 ( Tee piece ( Té
20 86374980 1 ( Adjusting screw ( Vis de réglage
30 86374998 1 ( Plug ( Bouchon
40 86249190 1 ( Nut ( Ecrou
50 86262656 1 ( O’ring ( Joint torique
40
30
20
10
40
50
20
30
10 Every 400 hours.
Depending on applications.
Every 1600 hours.
Long term, only if damaged.
Every 100 hours.
Every 800 hours.
PARTS TO CHANGE
Item CPN QtyE MONTABERT -- 2010
1.7
Fixation Fixation10 86331105 2 UNF 3/4”, hex. screw Vis H UNF 3/4”
20 86241940 2 Spacer Entretoise
30 86222882 2 UNF 3/4”, hex. nut Ecrou H UNF 3/4”
accessories accessoiresD 86334281 1 Seals kit including : Pochette de rechange comp. :
( All parts marked D ( Toutes pièces notées D
10
20
30
438 Nm + graisse graphitée322 ft.lb + graphite grease
Every 400 hours.
Depending on applications.
Every 1600 hours.
Long term, only if damaged.
Every 100 hours.
Every 800 hours.
PARTS TO CHANGE
203, route de GrenobleBP 67169805 Saint---Priest CedexFrance
www.montabert.com
top related