adhesion method single whispertek feb 16 2016

7/24/2019 Adhesion Method Single WhisperTek Feb 16 2016

1/14

NSUR1-1 WhisperTeksurfaceSingle installation guide

Span ideaon system


2/14

WHAT YOULL NEED

Laser level 3" roller

Two (2) people toinstall the surface.

TABLE OF CONTENTS

Before you begin

Step 1 Measuring and marking

Step 2

Aligning the surface

Step 3 Adhering the surface

3

4

6

9

Measuring tape


3/14

WhisperTek

TM

Surface installationhttp://nureva-span.uservoice.com/knowledgebase/articles/603927

70F 21C

To avoid cracking, ensure your surface has reached room

temperature before removing from the box. Allow thesurface to rest and flatten before installation.

BEFORE YOU BEGIN


4/14

STEP 1

MEASURING AND MARKING


5/14

Measuring and marking

Set up the laser lever and project a line 1" above the projected image.

Find the overall centerline of the system. The surface is 124" (314 cm) long and should extend 1" past the projectedimage on either side. Once you have found the centerline, use a straight edge to make a 2-inch mark that extendsabove the laser level line.


6/14

STEP 2

ALIGNING THE SURFACE


7/14

Peel the adhesive liner

Carefully flip the surface so the adhesive liner is facing up. Fold down a 6-inch wide horizoon one side along the top of the surface from the outside edge to where the liner is cut in Fold down a corner of the liner on the other side of the cut line.

On the front of the surface, use a pencil to make a small mark at the top of the surface on the scenterline.


8/14

Align the surface

Do not let the exposed adhesive touch the wall during this step.

Align the top edge of the surface with the laser level and the centerline mark on the front of thesurface with the system centerline mark on the wall.


9/14

ST EP 3

ADHERING THE SURFACE


10/14

Adhere the top of the surface

Person B presses the exposed adhesive

against the wall ensuring it is level

with the laser line then firmly smooths

the top of the surface against the wall.

Hold the surface in place

Once the surface is aligned, person A holds thesurface firmly against the wall.


11/14

Remove the adhesive liner

While person A holds one side of the surface, person B pulls the bottom of the surface away fromthe wall to remove the release liner. Do not bend the surface at a sharp angle as this can causekinking.


12/14

Begin adhering the surface to the wall

Starting from the top of the surface and moving downward, person B begins to press the surface against the

wall with overlapping up-and-down strokes to prevent bubbles from forming under the surface.


13/14

Adhere the second half of the surface

Once the first half is adhered, person A pulls the surface away from the wall from the side carefully while avoiding

kinking the surface in the center. Person B goes behind the surface to remove the adhesive liner from the second half of

the surface.

Person A holds the outside edge of the surface while person B smooths it against the wall using up-and-down strokes.


14/14

Roller the surface

Apply pressure to the surface using the 3" roller to promote proper adhesion. The surface is now ready foruse.

2016 Nureva Inc. All rights reserved. Nureva, Span, WhisperTek and the Span logo are trademarks of Nureva Inc. in the United States, Canada and other countries.

adhesion method single whispertek feb 16 2016

Documents