aac ventilation control(1)
TRANSCRIPT
-
8/22/2019 AAC Ventilation Control(1)
1/12
Manufactured by:
Rev. 6.17.09
Distributed by:
AAC Ventilation Controls
AAC Blocks Providethe Strength andPerformance toEnsure Safety
This submittal packet includes:
MSHA Accepted: ST30/01aMSHA Accepted: ST30/02MSHA Accepted ST30/00Hebel AAC- MSDSHebel Thin bed Mortar MSDS
-
8/22/2019 AAC Ventilation Control(1)
2/12
Xella Aircrete North America, Inc.2400 Hebel Boulevard
Adel, GA 31620
877-41-HEBEL www.hebel-usa.com
Manufactured
Rev. 6.1
Easy to Cut
Lightweight
Fire Resistant, Non Combustible
Convenience of Short Stack Packagin
Ease of Constructability
No Need for Dry Storage, MoistureResistant
Short Stack Pallet Sizes:
Tongue and Groove or Standard BlocksThickness 6" or 8"Class AAC-2 or AAC-4AAC Shipping Density 45 pcfBlock Dimensions: 6"x 8"x 24", 6"x 12"x 24"
8"x 8"x 24", 8"x 12"x 24"Dry or Wet StackAny MSHA listed Suitable Sealant
HEBEL AAC (AutoclavedAerated Concrete) provides alightweight solution to easelabor and increaseperformance of ventilationcontrols.
Block: ThxHxL =8.0x 12.0x 24.0Pallet: LxWxH =48.0x 48.0 x 36.036 Blocks / Pallet
Block: ThxHxL =6.0x 12.0x 24.0Pallet: LxWxH =48.0x 48.0 x 36.048 Blocks / Pallet
Block: ThxHxL =6.0x 8.0x 24.0Pallet: LxWxH =48.0x 48.0 x 36.072 Blocks / Pallet
Block: ThxHxL =8.0x 8.0x 24.0Pallet: LxWxH =48.0x 48.0 x 32.048 Blocks / Pallet
-
8/22/2019 AAC Ventilation Control(1)
3/12
-
8/22/2019 AAC Ventilation Control(1)
4/12
-
8/22/2019 AAC Ventilation Control(1)
5/12
-
8/22/2019 AAC Ventilation Control(1)
6/12
-
8/22/2019 AAC Ventilation Control(1)
7/12
-
8/22/2019 AAC Ventilation Control(1)
8/12
-
8/22/2019 AAC Ventilation Control(1)
9/12
Page 1 of 2
Mater ia l Safe ty Data Sheet
AUTOCLAVED AERATED CONCRETE (AAC)
SE CTION I. PR ODUCT IDENTIFICATION
P r o d u c t N a m e : H E B E L - Autoclaved Aerated Concrete (AAC)
P r o d u c t U s e : Load bearing and non load bearing components for interior and exterior wall,floor and roof slabs.
M a n u f a c t u r e r s I n f o r m a t i o n : X e l l a A i r c r e t e N o r t h A m e r i c a I n c .2400 Hebel BoulevardAdel, Georgia 31620
T e l e p h o n e : 229.896.1593 (Tel)229.896.1912 (Fax)
SE CTION II. HAZARDOUS INGREDIENTS
COMPONENT CA S No. % by Weight OS HA P EL (mg/m3) ACGI H TLV (mg/m
3)
P o r t l a n d C e m e n t 65977-15-1 28 5 10S i l i c a 14808-60-7 50 0.1 0.1L i m e 39445-23-3 12 5 10G y p s u m 7778-18-9 10 5 10E x p a n d i n g A g e n t PA TENT ED 0.1 - 0.15 -- --
SE CTION III. PHYSIC AL DATA
Boiling P oint : N/A S pecific Gravity: 0.5-0.7Vapor P ressure: N/A Evaporation Rate: N/AVapor Density (Air=1): N/A Melting P oint: N/AS olubility in Water (%wt) N/A Volatiles (by vol.): N/ApH: 9.0-10.5 VO Cs (g/lt) N/AAppearance and odor: White solid with no odor
SE CTION IV. FIRE AND EXP LOSION HAZARDS
Flash P oint : N/AFlammability (LE L,HE L) N/AHazardous combustion products: NoneUnusual fire and explosion hazards: NoneS pecial F irefighting procedures: The applicable for surrounding materials and substances
SE CTION V. REACT IVITY DATA
Stability: StableCo nditions to avoid: NoneIncompatible materials: None, this is an inert material
Hazardous decomposition products: NoneHazardous polymerization: Will not occur
SE CTION VI. HEALTH HAZARD DATA
EFFECTS OF ACUTE OVEREXP OSURE:No ac ute effects are related to the use of this product.
EFFECTS OF CHRONIC OVEREXP OSURE:Long-term overexposure to high concentrations of dust without the use of a dust mask may reduce respiratoryfunction in some individuals.
-
8/22/2019 AAC Ventilation Control(1)
10/12
Page 2 of 2
INHALATION:When cutting the material, dust particles are generated. R espiratory tract must be protected. Irritation of noseand upper respiratory tract, shortness of breath. P rolonged inhalation of excessive s ilica dus t may reduce lungfunction.
E Y E S :No s pecific health hazards are related to this route of exposure. When cutting the material, eyes must beprotected against dust generated.
SK IN:Handling may cause dry skin. A void contact to skin.
ING ES TI ON : Not applicable under normal use. May result in obstruction and temporary irritation of thedigestive tract if large quantities are cons umed.
MEDICAL CONDITIONS AGGRAVATEDBY EXP OSURE:Unknown
SE CTION VII. FIRST AID MEASURE S INHALATION:Re move to fresh air. If persis tent irritation, se vere coughing, or breathing difficulty occurs s eek medicalattention.
EYE CONTACT:
Re move contact lenses. Fl ush eyes, i ncluding under eyelids, with large amounts of water for 15 minutes.If i rritation persis ts, see k medical attention.
SK IN CONTACT:Wash affected areas with soap and water. If irritation persists seek medical attention.
INGESTION:May result in obstruction if ingested. S eek medical attention.
SECTION VII I. SP ECIAL P ROTECTIONRESP IRATORY PROTECTION:Dust mask must be worn for dust generating operations.
PROTECTIVE GLOVES:
As recommended for cons truction operations.
EYE PROTECTION:Use of protective safety glasses or goggles is recommended for dust generating operations.
SECTION IX. ADDITIONAL INFORMATION
AA C dust contains crystalline silica which has been evaluated as Group 2A (probably carcinogenic to humans) bythe International Agency for Research on Cancer (IARC).
WASTE DISPOSAL:F ollow the above safety instructions, coll ect waste and dust by sweeping or vacuuming and place in containers.Dispos e of containers and waste according to local, state or federal regulations.
The in formation conta ined in thi s material S afety Da ta S heet is beli eved to be reli ab le . No guarantee is impli edor expressed regarding the accuracy of this information or the use of the product since the conditions of use arebeyond manufacturers control. N othing contained herein should be construed as a recommendation to use thisproduct in conflict with existing patents c overing any material or its use.
This MS DS was generated from in formatio n avai lable of components of thi s product. I t compl ies with minimumrequirements stated by OSHA as defined in Section G, 29CFR1910.1200.MS DS date of preparation: 04/19/07
-
8/22/2019 AAC Ventilation Control(1)
11/12
Material Safety Data Sheet
ELITE BUILDING PRODUCTS, INC. 4235 Buford Highway Duluth, Georgia 30096 (678) 206-0242 fax (678) 206-0254
II. Hazardous Ingredients
Material CAS No. OSHA PEL: mg/m3 ACGIH TLV mg/m3
Portland Cement 65977-15-1 5 10
Silica 14808-60-7 0.1 0.1
Vinyl 1216-01 5 10
III. Health Hazard Data
Routes of Hazard
Exposure Determination
Inhalation
Basis for Determination
Contains Silica*
* Prolonged inhalation of excessive silica dust may
reduce lung function.Effects of Acute Overexposure No acute effects.
Effects of Chronic Overexposure Long term overexposure to high concentrations of thisdust without the use of a dust mask may reduce
respiratory function in some individuals.
Medical Condition Aggravated by Exposure Unknown
Eyes and Skin No special precautions. Flush with water for 15 minutes.
Inhalation and Ingestion No special precautions.
I. Product Identification
Product Name Hebel Thinbed Mortar Manufacturers Name
Phone (678) 206-0242
Elite Building Products, Inc.4235 Buford HighwayDuluth, GA 30096
IV. Physical Data
Boiling Point N/A pH 12
Vapor Pressure N/A Specific Gravity 2.8
Vapor Density N/A Melting Point N/A
Solubility in Water Negligible Evaporation Rate N/A
Appearance and Odor Whiteish
-
8/22/2019 AAC Ventilation Control(1)
12/12
V. Fire and Explosion Data
Flash Point None Special Fire Fighting Procedures None
Flammable Limits in Air N/A Unusual Fire and Explosion Hazard None
Auto Ignition Temperature None
VI. Reactivity Data
Conditions Contributing to Instability Reacts with acids to liberate CO2
Conditions Contributing to Hazardous Polymerization None
Hazardous Decomposition Products None
VII. Disposal, Spill, or Leak Procedures
Waste Disposal Method Material is not classified as a hazardous waste under RCRA Section 3001. Usenormal solid waste disposal procedures which are in compliance with Federal,
State and Local Regulations.
Spill or Leak Procedures Material is not classified as a toxic pollutant or a hazardous substance underSection 307 and 311 of the Clean Water Act. Accidental releases can be
cleaned up by sweeping, vacuuming, or flushing with water.
Neutralizing Chemicals None required.
VIII. Special Protection Information
Ventilation Use sufficient general area ventilation. Local exhaust may benecessary where Threshold Limit Values (TLVs) are exceeded or
dusty conditions exists.
Personal Protective Equipment
Eyes Recommended
Gloves Recommended
Other None
Respiratory Protection For dusty conditions use a dust mask approved by NIOAH.
ELITE BUILDING PRODUCTS, INC. 4235 Buford Highway Duluth, Georgia 30096 (678) 206-0242 fax (678) 206-0254
The information contained in this Material Safety Data Sheet is believed to be reliable. No guarantee is implied or expressedregarding the accuracy of this information or the use of the product since the conditions for use are beyond our control. Nothingcontained herein should be construed as a recommendation to use this product in conflict with existing patents covering any
material or its use.