TRIU

MP

H-1

MG

PS +

GLO

NA

SS +

Gal

ileo+

Bei

Dou

+Q

ZSS

900 Rock Avenue, San Jose, CA 95131 USA Phone: +1(408)770-1770 Fax: +1(408)770-1799

www.javad.comCopyright © JAVAD GNSS, Inc., 2014

Download:• TRIUMPH-1M User Manual• Latest firmware version• USB driver• NGS Informationhttp://www.javad.com/jgnss/products/receivers/triumph-1m.html

54.4

88.75

182*

L2 U

p O

ffset

: 90.

77

L1 U

p O

ffset

: 89.

19

236.

4*

1. All dimensions are in mm2. * Reference dimension3. ARP - Antenna Reference Point SHMP - Slant Height Measurement Point NOM - North Orientation Mark

ARP

SHMP, NOM

4. Antenna Type: JAVTRIUMPH_1MR NONE

SIM and SD Card SlotTo install the SIM and SD cards:• Ensure the receiver is turned off.• Open the SIM/SD card cover.• Carefully insert the SIM and/or SD cards into the slots and push them to lock them tightly.• Close the cover.

MinPadTRIUMPH-1M is very simple to operate. Turn it on and six green lights, one after the other, glow to tell you that all is going well.The ON/OFF button turns the receiver on and off.

Quick Start Guide Revision 1.1From October 13, 2014

CommunicationCommunication with TRIUMPH-1M is easy. In addition to two serial ports (A and B) and a USB, TRIUMPH-1M also has Ethernet connectivity.

• Power – used to connect the re-ceiver to an external power source. • Serial – used for communication between the receiver and an exter-nal device. • Ethernet - used to connect the receiver to local network. • USB – used for high-speed data transfer and communication be-tween the receiver and an external device.

TRIUMPH-1M

1. LED solid according to the battery means receiver is ON without external power. Blinking every 1 sec according to the battery means external power is connected. 2. Effective number of satellites are total number of satellites tracked minus the number of non-GPS systems tracked. For example if 8 GPS and 5 GLONASS are tracked the effective number of satellites is 12.3. RECORDING LED blinks on each recording.

Function Green Yellow Red OFFBATTERY1 Full Half Almost Empty OFF/No power

BLUETOOTH Connected Searching No connection Not Active

MODEM Connected Marginal Connectivity No connection Not Active

SATELLITES2 8 or more 5 to 7 Less than 5 No Satellite

POSITION Fixed/Diff/ OK (Base) Float/No-Diff No Position Receiver OFF

RECORDING3 Recording Less than 10 min memory left Memory Full Not Active

FN button starts/stops data recording. Holding both FN and ON/OFF buttons down for more than 30 seconds will reset the receiver. Holding FN down while turn-ing receiver ON using ON/OFF button (or after resetting receiver) until four LEDs start to blink yellow and than releasing FN button while four LEDs still blink yellow will bring receiver to its initial factory-default state (i.e., will clear NVRAM).

UHF/Cellular Antenna

SHMP, NOM