7” fascia bracket assembly instructions · idle end for center support/intemediate bkt...
TRANSCRIPT
F - 9
7” FASCIA BRACKET ASSEMBLY INSTRUCTIONS
1. Install idle end plate with all 8 screws 6mm long x 4m pan head Philip drive. 2. Then install idle end bracket to wall/ceiling. 3. Next install one screw 6mm long x 4m pan head Philip drive at the top right corner of the clutch insert plate. 4. Then install clutch end bracket to wall/ceiling. 5. Then you can install the 1 ½”clutch blind with ball chain. 6. Next install a chain guide in the middle of the insert plate with 3 screws 18mm long x4m pan head Philip drive 7. Then you can install 1 ¾” clutch, blind and ball chain. 8. Next install a chain guide in the bottom of the insert plate with 3 screws 18mm long x 4m pan head Philip drive.
Picture shows # 1. Instruction completed
Picture shows # 3. Instruction completed
Picture shows # 5. Instruction completed.
Picture shows # 7. Instruction completed.
Notch and opening at the clutch end of the fascia
¾”
1.7/8”
The notch size is 1.7/8”deep x
3/4”long.
TUBE AND FABRIC DEDUCTION
7" FASCIA BRACKETS
US F-10
12
6
4
53
12
7 4
5
3
8RS-3TU RS-T5*
RS-033
RS-2TU
1 2
9
4
610
5
RS-T4*
3
2
9
4
6
7
7
10
10
11
11
38
RS-033
# DESCRIPTION ITEM # CATALOG PAGE
7" Square Fascia End Cap RS-WY* F-71
1
5
RS-2TURS-T4*
RS-3TU RS-T5*
7 Square Fascia End Cap RS-WY* F-7
7"Fascia Bracket RS-WT* F-7
7"Insert Plates for 1 1/2"&1 3/4"Clutch RS-WU* F-7
Clutch RM-221/2CX/2CR A-5
Clutch RM-222/3CX/3CR A-5
Tube RS-2TU/T4* A-1,A-26
5
1
2
3
4
Tube RS 2TU/T4 A 1,A 2
7 Tube RS-3TU/RS-T5*/RS033 A-1,A-2
8 7"Fascia RS-SK* F-7
9 7"Center Support/Intermediate Bracket RS-W7*/RS-W6* F-8
Idle end for Center Support/Intemediate bkt RS-WQ6(3)/WQ5(1),WM2(1) E-1,E-2,E-4
Idle end for Center Support/Intemediate bkt RS-WQ4/WQ2,WM3 E-1,E-2,E-411
6
10
US F-10