2007-2013 CHEVY® TAHOE®,SUBURBAN®, OR AVALANCHE®

FOG LIGHT MOUNT

INSTALLATION INSTRUCTIONS

*THIS MOUNT FITS THE FOLLOWING LIGHTS: (2) D-SERIES®

PRODUCT INCLUDES:(1) Mount #46577(2) 5/16-18 x 2” Long SS Carriage Bolts(4) 5/16-18 x 3/4” Long SS Carriage Bolts (6) 5/16 SS Nuts(6) SS Split Lock Washers(6) SS Flat Washers (2) 1.25” Long x 0.315” I.D. Spacers

* LIGHTS SOLD SEPARATELY

IMPORTANTTHANK YOU FOR PURCHASING RIGID INDUSTRIES’ PRODUCTS FOR YOUR VEHICLE.

Installation is fairly simple with the right tools and good mechanical abilities. If you are not confident in your mechanical skills, please seek the help of a professional to perform the installation. Please read

through all of these instructions and tips before proceeding with the installation.

It is strongly recommended that this product be installed by a professional.

Always disconnect any power sources connected to your vehiclebefore servicing fuses or electrical systems.

FIGURE 1

FIGURE 2

FIGURE 3

STEP 1Remove and save (2) 7mm bolts and push back fender wall.

See Figure 1

STEP 2Un-clip factory fog light.

See Figure 2

STEP 3Pinch (3) black tabs and removefog light.

See Figure 3

FIGURE 4.1

FIGURE 4.2

STEP 5Repeat Steps 1 – 4 for remaining side.

FIGURE 4STEP 4Install Rigid Industries back plate with (1) 5/16-18 x 2” long SS Carriage bolt, (1) 1.25” Long x 0.315 I.D. Spacers,(1) SS Split lock washer,(1) SS Flat washer, (1) 5/16 SS nut, (2) 5/16-18x3/4” long SS Carriage bolts, (2) SS Split lock washers, (2) SS Flat washers, and (2) 5/16 SS nuts .

See Figures 4, 4.1, and 4.2

WARRANTY INFORMATIONFor warranty information, visit www.rigidindustries.com/about/warranty

779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337www.rigidindustries.com

D-Series and Rigid Industries are registered and/or common law marks owned by JST Performance, LLC,a Delaware limited liability company d/b/a Rigid Industries.

PKG-IS-212-A

Wiring: Wire your lights according to the instructions included with the light.Take care to avoid any heat sources and sharp or abrasive surfaces.

Your installation is now complete.Welcome to the Rigid Nation!

FIGURE 6STEP 6Install Rigid Industries light using hardware provided with the light.

See Figure 6