Proprietary and Confidential

FibeAir IP-10 G-SeriesAdvanced QoS Configuration

®

Proprietary and Confidential

Agenda

2

• VLAN P-Bit Re-Map – Why?

• Configuring the Re-Map Table

• Queuing without Re-Map

• Queuing with next classifier + Re-Map

• Queuing + Re-Map

• IP ToS over VLAN P-Bits

• VLAN P-Bits over IP ToS

• Using more than a single Classifier

Proprietary and Confidential

P-Bit Re-Map: Why?• Re-Map table is per port (e.g. every port can apply a different map)

• Can be used to re-scale Customer CoS

• Can be used to guaranty certain Customer priorities are reserved for specific purposes

3

Customer network

L2 Switch(IP-10) Provider

network

P-Bit Service

0 - 2 Video

3 – 4 Data

5 – 6 MNG

7 Voice

P-Bit* Service

0 - 5 Best Effort

6 MNG

7 Voice

Proprietary and Confidential

Configuring the Mapping TableClick on the “VLAN Pbits Remap Table” link to configure relevant settings

4

Proprietary and Confidential

Queuing without Re-Mapping

Ingress Rate Limit

Queuingaccording to classifier

Egress Scheduler

Egress Shaper

Ingress Tagged frame

VID P-bit VID P-bit

5

Proprietary and Confidential

Skipping to next classifier with Re-Map

6

Ingress Rate Limit

Queuingaccording to next classifier

Egress Scheduler

Egress Shaper

Ingress Tagged frame

VID P-bit VID P-bit*

Re-Map Table

Proprietary and Confidential

Queuing and Re-Mapping

7

Ingress Rate Limit

Egress Scheduler

Egress Shaper

Ingress Tagged frame

VID P-bit VID P-bit*

Re-Map Table

Queuingaccording to classifier

Conditional Classification

Proprietary and Confidential

IP ToS over VLAN P-Bits

9

In case the ingress frame carries a VLAN and has an IP header - Classification is according to IP TOS

Otherwise the switch will apply the Default Configuration (Queue number).

L2 Tagged ETH L3 IP Header

Proprietary and Confidential

VLAN P-Bits over IP ToS

10

In case the ingress frame carries a VLAN and has an IP header - Classification is according to VLAN P-Bits

Otherwise the switch will apply the Default Configuration (Queue number).

L2 Tagged ETH L3 IP Header

Proprietary and Confidential

Using more than a single Classifier

11

As long as the ingress frames comply to the higher conditions, the system will not check lower conditions (Classifiers)

If higher condition is not matched, the system will proceed to the lower condition and so on…

Proprietary and Confidential

Using more than a single Classifier

12

2nd criteria: VLAN ID

100 Highest

100 Highest

100 Highest

100 Highest

200 Lowest

3rd criteria: P-Tag

7 Highest

6

3

2

0 Lowest

Ingress frames

100 or 200

Different than 100 or 200

VID = ?

Audit VID : if VID = 100 than apply “High Service” otherwise - if VID = 200 than apply “Low Service”

Otherwise –

If ingress VID does not qualify (100 or 200)

then skip to -

Audit VLAN P-bits

13

Thank You !training@ceragon.com