1.1.4.a component identification - digital...
TRANSCRIPT
Activity 1.1.4 Component Identification
Procedure1. Using Activity 1.1.4 Component Identification posted on course website (wardende.weebly.com),
determine the nominal resistance value for the following components. Express your answers using the proper SI units and prefix.
(Yellow / Violet / Red / Gold)(Green / Blue / Yellow / Gold)
Ra = ____________________________ Rb = ____________________________
(Brown / Red / Green / Gold) (Red / Violet / Brown / Gold)
Rc = ____________________________ Rd = ____________________________
(Blue / Gray / Orange / Gold)
Re = ____________________________
© 2014 Project Lead The Way, Inc. Digital Electronics Activity 1.1.4 Component Identification – Page 1
2. Obtain 6 random resistors from your instructor. Using the Resistor Color Code Diagram, record each resistors nominal value and tolerance range. Next, use a digital multi-meter (DMM) to measure and record the actual resistance value of each resistor. Finally, indicate if the measured value is within acceptable tolerance.
Resistor ColorsNominal
Value
Tolerance RangeMeasured
ValueMeets
Tolerance?Minimum Accepted
Value
Maximum Accepted Value
1
2
3
4
5
6
3. Use the attached Disc Capacitor Label Diagram to determine the nominal capacitance value for the following components.
Ca = ____________________ Cb=______________________
© 2014 Project Lead The Way, Inc. Digital Electronics Activity 1.1.4 Component Identification – Page 2
Cc = _____________________ Cd = _____________________
Resistor Color Code
Ce = _____________________
© 2014 Project Lead The Way, Inc. Digital Electronics Activity 1.1.4 Component Identification – Page 3
Disc Capacitor Label Diagram
Conclusion
1. Why are the measured values of the resistors different from the nominal values?
2. Identify each of the circled components for the printed circuit board shown below.
A. ________________________
B. ________________________
C. ________________________
D. ________________________
E. ________________________
F. ________________________
© 2014 Project Lead The Way, Inc. Digital Electronics Activity 1.1.4 Component Identification – Page 4
4
First Digit
Second Digit
Third Digit# of Zeros
Fourth Digit
Tolerance
7 2 K
4 7 00 K4700 pF 10%
A B
C
D
F
E