The General (Universal) Zones of Treatment.

These zones are called “general” because treatment in have areas these influence on many organs andsystems of the human body. As a result , zones these of the treatment of you can observe generalreactions of the body ability body's the as: such adaptati including factors, stress harmful various on to

or sthe trengthening regulation of immune system the or acceleration etc.of convalesence...

1. List of General Zones:

There are a few general zones that for considering are we treatment purposes:1. “3 Pathways+6 points”2. “Neck Collar Zone”3. “Palm Zone”

2. Indication for using General (Universal) Zones:

1. Patient has few complaints at present (for example, back pain and headache etc.) or undefinedcomplaint (weakness, fatigue, drowsiness, extended pain etc). Treatment of general zones will help:

- to reveal the asymmetry (pathological spots) over the general zones and learn the effectsthat improving are health (and providing pain relief as ) of result a treatment.- to localize and specify complaints (for example: after treatment of the general zones, the patient can one only you show painful area that we can immediately treat

). 2. You want to influence many organs and systems of the human body to achieve general healthful effects.

3. Treatment of “3 pathways+6 points” Zone

“3 pathways+6 points” is the main method of DENS Therapy for general influence. First of all, wealways diagnose all spots within this zone in order to find and treat pathological ones only. Thereare few ways (versions) to diagnose and treat this zone.

I. The Classical variant using method: works MED Mode (for the Classic DENAS - “Doze Mode”).

1. Set up your individual energy level (comfortable tingle sensation), turn on MED mode.2. Find 7th cervical vertebra. This is most prominent vertebra in the neck.

3. Do not diagnose and treat the projection of 7th cervical vertebra, but place electrode vertebra the onjust position using measuring first the be will This below. the device.

4. Place electrode on the skin (be sure you are in MED mode). Do not move the DiaDENS devic eover the skin. When first phase of MED completes, the device gives you a sound signal and LCD screen fixes the time. Remember this time and remove device from the skin. Then place electrode on the second position and do the same. Compare the time. Lesser time is estimated as more active spot which needs further treatment. In our example , case it is 15 seconds (see image below). Place electrode there and theget time again. Repeat this action 2 times (3 times in whole – 3 “Full Doses”) on the same spot and count total time for this spot (summarize 3 times of the reply) . Say, in our case it will be 90 seconds. Remember this time also.

5. Continue finding more active spots (order of placements is shown in the picture below). Youshould find spot with time of initial reply lesser then last active spot (in our case it was spot with 15seconds reply).

6. If you found a spot with lesser time of response, treat one as it explained in point 4. In the last position (see picture below) we should always treat a spot pathological independently of its time.

7. Compare time of all treated spots (spots where you made 3 “Full Doses”). Find spot with lessertime and treat it during 2 minutes using 77 Hz or “77-10” regimen (for Diadens-PCM, Diadens-PC owners). In our case it is 80-seconds area.

9. Next step is diagnostic and treatment of second and third pathways (see location of this pathwaysin the picture below). Please use the same principle to find and treat pathological spots.

10. Diagnose and treat next area – 6 points on the face. Use order of electrode's placements like itshown in the picture below. Apply the same principle as you used for 3 pathways treatment.