01- sealing outdoor connectors antennas
DESCRIPTION
Outdoor Connectors AntennasTRANSCRIPT
-
23 Sealing Outdoor ConnectorsTo prevent outdoor cables from aging and to maintain their stable performance, you need to sealthe outdoor connectors. This topic illustrates how to seal an outdoor feeder connector.
Prerequisitel The materials required for sealing the outdoor connector are ready. The materials are PVC
insulating tape and waterproof tape, as shown in Figure 23-1.
Figure 23-1 PVC insulating tape and waterproof tape
(1) PVC insulating tape (2) Waterproof tape
l The tools, such as scissors, required for sealing the outdoor connector are ready.l The feeder connector to be sealed has passed the Voltage Standing-Wave Ratio (VSWR)
test.
ProcedureStep 1 Wrap the connector by using waterproof tape, as shown in Figure 23-2.
1. Wrap the connector from the point 20 mm [0.79 in.] away from the end of the connectorto the point 20 mm [0.79 in.] away from the other end of the connector.
2. Do not cut off the waterproof tape and continue to wrap the connector for the second andthird time.
3. After the connector is wrapped three times, cut off the waterproof tape.
NodeBAntenna System User Guide-RET 23 Sealing Outdoor Connectors
Issue 02 (2008-01-30) Huawei Proprietary and ConfidentialCopyright Huawei Technologies Co., Ltd
23-1
-
Figure 23-2 Wrapping the connector in three layers of waterproof tape
CAUTIONl Ensure that each layer covers at least 50% surface of the layer below it.l Stretch the waterproof tape evenly to 1/2 of its original width so that it clings properly to the
connector.
Step 2 Hold and press the wrapped waterproof tape to ensure that the connector is tightly and evenlywrapped, as shown in Figure 23-3.
Figure 23-3 Holding and pressing the wrapped waterproof tape
Step 3 Wrap the connector by using PVC insulating tape, as shown in Figure 23-4.1. Wrap the connector and ensure that the PVC insulating tape completely covers the
waterproof tape and extends beyond the waterproof tape by 20 mm [0.79 in.] at both ends.2. Do not cut off the PVC insulating tape and continue to wrap the connector for the second
and third time.
23 Sealing Outdoor ConnectorsNodeB
Antenna System User Guide-RET
23-2 Huawei Proprietary and ConfidentialCopyright Huawei Technologies Co., Ltd
Issue 02 (2008-01-30)
-
3. After the connector is wrapped three times, cut off the PVC insulating tape.
Figure 23-4 Wrapping the connector in three layers of PVC insulating tape
CAUTIONEnsure that each layer covers at least 50% surface of the layer below it.
Step 4 Hold and press the wrapped PVC insulating tape to ensure that the connector is tightly and evenlywrapped, as shown in Figure 23-5.
Figure 23-5 Holding and pressing the PVC insulating tape
Step 5 Use two cable ties to bind the PVC insulating tape at both ends, as shown in Figure 23-6.
NodeBAntenna System User Guide-RET 23 Sealing Outdoor Connectors
Issue 02 (2008-01-30) Huawei Proprietary and ConfidentialCopyright Huawei Technologies Co., Ltd
23-3
-
Figure 23-6 Wrapped feeder connector
----End
23 Sealing Outdoor ConnectorsNodeB
Antenna System User Guide-RET
23-4 Huawei Proprietary and ConfidentialCopyright Huawei Technologies Co., Ltd
Issue 02 (2008-01-30)
23 Sealing Outdoor Connectors